Home > Wayne Dalton >

Wayne Dalton Replacement IDrive Internal Disconnect Cable
Wayne Dalton I Drive Internal Disconnect Cable
Wayne Dalton I Drive Internal Disconnect Cable
 
Alternative Views:


List Price:$95.91
Our Price:$75.93


Availability: Currently Unavailable
Product Code: TMS-INTERNAL-DISCONNECT-CABLE
**DISCONTINUED-CHECK EBAY**

Description Technical Specs Manuals and Helpful Tips
 
Wayne Dalton Replacement iDrive Internal Disconnect Cable.

This item is not returnable.


Features
For torquemaster and can also be used for the torsion Wayne Dalton I Drive garage door openers.
You may need to adjust the length of the cable for your disconnect handle if used on a iDrive Torsion operator.

Average Customer Review: Average Customer Review: 5 of 5 5 of 5 Total Reviews: 7 Write a review.

  3 of 3 people found the following review helpful:
 
5 of 5 Fit perfectly April 20, 2019
Reviewer: Steve D. from Severn, MD United States  
Kind of expensive for a short release cable but it is OEM fit.

Was this review helpful to you?

  3 of 3 people found the following review helpful:
 
5 of 5 October 28, 2018
Reviewer: Bobby Jones from Crosby, TX United States  


Was this review helpful to you?

  7 of 7 people found the following review helpful:
 
5 of 5 Disconnect Cable February 7, 2018
Reviewer: Anonymous Person  
It fit perfectly  would buy from again...

Was this review helpful to you?

  7 of 7 people found the following review helpful:
 
5 of 5 Internal release cable December 30, 2017
Reviewer: Thomas Hawkins from Dallas, GA United States  
Cable received promptly and fit. Just a dog to put in while opener was still installed.
Happy customer.
Thanks

Was this review helpful to you?

  8 of 8 people found the following review helpful:
 
5 of 5 Comments on purchased productions November 21, 2017
Reviewer: Bruce Macdonald from Moreno Valley, CA United States  
Your product is the only one available to replace a broken original.  In this, I am totally greatfull

Your part took me 1.5 hours to install.  This is not your fault but in the design of the opener.  The poor design of the IDrive uses sliding punched steel plates that are not wide enough and frustrate the cable installation.  The hoop is used to lift one plate over another, but it's back is open to the edge of the plate below, possibly wearing the cable until it breaks.  The hoop should be a tube.  

Finally with the use of a flat blade screw driver, I was able to manoeuvre the cable out of the hoop.  Possibly you could offer a shim to facilitate your products installation.

Was this review helpful to you?

View All Customer Reviews

Browse for more products in the same category as this item:

Wayne Dalton
Wayne Dalton > Idrive Parts