To Prepare to Use

Program transmitter into receiver. Refer to the instructions provided with the receiver to set it into a “learning” mode. Activate the transmitter to program it into the receiver.

Receivers that accept “Block Coding” Can be programmed to accept a user defined block of ID codes, in addition to “learning” individual transmitter “ID’s”.

To Replace Batteries

Step 1 Open the Case.

Remove the two retaining screws from the rear of the case. Hold the case halves together and flip the transmitter over. Lay the unit on a table with the button(s) facing up. Carefully remove the case top.

Step 2 Remove the board.

Very carefully remove the circuit board and set it aside. Notice how the batteries are placed in the bottom case of the transmitter.

Step 3 Replace the batteries.

Remove the old batteries, noting their location and placement. Replace the batteries with fresh type CR1616, CR1620 or DL 1620 batteries. Both batteries must be the same type.

Step 4 Close the case.

Carefully place the circuit board into the case over the batteries. Align the board on the two case alignment posts. Hook the top case onto the bottom case on the button end. Squeeze the case together, flip it over and replace the two case screws. Test the transmitter for proper operation.